A MEMS Clearinghouse® and information portal
for the MEMS and Nanotechnology community
RegisterSign-In
MEMSnet Home About Us What is MEMS? Beginner's Guide Discussion Groups Advertise Here
News
MEMSnet Home: MEMS-Talk: Photoresist for AU plating
Photoresist for AU plating
2003-06-24
[email protected]
2003-06-25
transene
Photoresist for AU plating
[email protected]
2003-06-24
I think ur gold bath is sightly alkaline, isn't it?
Alkaline will dissolve positive photoresists. I think you
might try negative photoresists instead since negative
photoresists doesn't dissovle in alkakine.

> Hi all,
>
> I was doing gold electroplating using cynide bath.I
> was doing plating on Si wafer sputtered with gold
> later covered with photoresist ,exposed and developed
> and hardbaked.
>
> after doing the above i have tried AU electroplating.I
> was  going for very low current densities and very low
> temperature and with optimum PH after very less time i
> could obsevere the plating of gold but the Photoresist
> is disturbed and the pattern was disturbed.
>
> Can i find any ways to improve adhesion of photoresist
> on AU surface.
>
> Ur suggestions are highly appreciated.
>
> Thanks
> Kris
>
>
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
>
> _______________________________________________
> [email protected] mailing list: to unsubscribe or
> change your list options, visit
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing
> services. Visit us at http://www.memsnet.org/

Best Regards,
Kin


reply
Events
Glossary
Materials
Links
MEMS-talk
Terms of Use | Contact Us | Search
MEMS Exchange
MEMS Industry Group
Coventor
Harrick Plasma
Tanner EDA
Addison Engineering
MEMStaff Inc.
Tanner EDA by Mentor Graphics
Mentor Graphics Corporation