Hi all,
Thanx a lot guys...Especially Philip Floyd...Some of you must have felt I asked
the question too late or I was just being lazy in putting it on this forum...But
some how I wasn't satisfied with the answers I got from all the books that I
read...And so I thought the question must be put to more experienced people like
you...Well to tell you more about myself...I am working on manufacturing MEMS
using Rapid Prototyping for the past 9 months and I am also writing a thesis on
it...I wish to do a PhD on the same...
More later...
Thanx again..

Atul Ranade.
Research assistant
Mechanical and Industrial engineering department.
University of Texas at El Paso


"Success never rests. On your worst days, be good. And on your best
days, be great. And on every other day, get better"
 - Carmen Mariano

---------------------------------
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software