Dipankar,

  The resistivity of Cu can  be reduced after annealing in Ar. But
it can be futher reduced if you are using a reducing gas like H.
The best resistivity we had for 50 nm film was about 1.8 micro ohm
cm.

Thanks
Sumant

On Fri, 18 Jun 2004 Dipankar Ghosh wrote :
>Hi all,
>
>          I am trying to sputter thick Cu ( 1 um) in a DC
>sputtering system.my sputtering conditions are as follows :-
>
>base pr- 10 exp(-6) torr
>
>chamber pr -10 m torr
>
>Ar gas flow - 10 sccm.
>
>power - 250 W
>
>Target to substrate distance - 5 cm.
>
>my problem is that the resistivity of my deposited Cu is very
>high (24 micro ohm cm) which is about 15 times the bulk
>resistivity of Cu( 1.6 micro ohm cm).
>
>does anybody any any experience with deposition of thick Cu with
>low resistivity values.pls let me know.
>        Thanks in advance,
>                   Dipankar
>
>OFFICE ADDRESS :-
>
>MATERIALS RESEARCH CENTER,
>ROOM 322 , RB-1,
>1001 CAPABILITY DRIVE,
>CENTENNIAL CAMPUS, NCSU,
>RALEIGH ,
>NC 27695-7919
>USA
>
>PH- 919 515 5049
>FAX- 919 515 3419
>
>
>
>
>
>
>
>
>
>
>____________________________________________________________
>Find what you are looking for with the Lycos Yellow Pages
>http://r.lycos.com/r/yp_emailfooter/http://yellowpages.lycos.com/default.asp?SR
C=lycos10
>_______________________________________________
>[email protected] mailing list: to unsubscribe or change your
>list
>options, visit
>http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>Hosted by the MEMS Exchange, providers of MEMS processing
>services.
>Visit us at http://www.memsnet.org/




Sumant Sood
http://pegasus.cc.ucf.edu/~ssood