A MEMS Clearinghouse® and information portal
for the MEMS and Nanotechnology community
RegisterSign-In
MEMSnet Home About Us What is MEMS? Beginner's Guide Discussion Groups Advertise Here
News
MEMSnet Home: MEMS-Talk: Deposition of thick SiO2 layer
Deposition of thick SiO2 layer
2004-08-31
Aamer Mahmood
2004-09-01
Doron Schlumm
2004-08-31
Kasman , Elina
2004-09-02
Sarfaraz Moh
Deposition of thick SiO2 layer
Kasman , Elina
2004-08-31
Different expansion coefficients, since the cracks are caused by curing.

Perhaps the polyimide is causing this
Have you tried a buffer layer that will absob the extra stress due to
heating?

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Aamer Mahmood
Sent: Tuesday, August 31, 2004 9:50 AM
To: [email protected]
Subject: [mems-talk] Deposition of thick SiO2 layer


Hello all,
I have deposited ~ 2-3um of SiO2 on a polyimide (PI2610). Subsequent
process steps require curing @ ~ 265 C. I notice big cracks in the Oxide
and also large chunks of it just peel off. Before resorting to
sputtering, I have also tried spin-on-glass but faced similar problems.
Any suggestions on the cause and/or remedy would be greatly appreciated.
Thanks.

Aamer Mahmood
Grad Res Assist
Microsensors lab
UT Arlington

_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/

reply
Events
Glossary
Materials
Links
MEMS-talk
Terms of Use | Contact Us | Search
MEMS Exchange
MEMS Industry Group
Coventor
Harrick Plasma
Tanner EDA
MEMStaff Inc.
Harrick Plasma, Inc.
Mentor Graphics Corporation
Nano-Master, Inc.