Kevin,

I have a bad experience. When I did TMAH etching at 40C, I used a Al foil to
cover the 2000ml beaker in order to keep the temperature stabe. Finally, the
foil turn grey (black) and lots of dusts drop off into solution. I guess the
TMAH evapor oxide al. but i am not sure.

Good luck,

Lydia


Quoting Kevin Duan :

> Hi, dear all
>
> I am planning to do TMAH etching of silicon wafer with aluminum
> pattern on it.  I want to achieve as low etch rate for Al as possible.
>  Some people add some silicon powder and some other additive, like
> amonium nitrate to do that.  Does anyone have some experience in doing
> so?  How about the experimental setup and the condition?
>
> Thanks ahead.
>
> Duan
> _______________________________________________
> [email protected] mailing list: to unsubscribe or change your list
> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing services.
> Visit us at http://www.memsnet.org/
>




-------------------------------------------------
This mail sent through IMP: http://horde.org/imp/