How about oxygen plasma plus a little bit of CF4 to make the
plasma etch more aggressive?

Patrick Cheung, research scientist   Xerox PARC, MS 35-1674
(O) 650-812-4338 (FAX) 650-812-4334   3333 Coyote Hill Road
[email protected]                  Palo Alto, CA 94304
>>                                                       >>
>>                                                       >>

On Wed, 18 Feb 1998, Sergio Palma Pacheco wrote:

I am using cured polyimide (PI 2545) as a sacrificial layer in a process
to
create long and wide airbridges.  I have been using hot (110C)
Ethylenediamine
to etch the polyimide, but it does not seem to remove all of the
material
underneath the bridges.  I have included holes to facilitate the
diffusion of the
etchant under the bridges as well as a stirrer, but to no avail.  Does
anyone
know of other etchants that could be used to remove the polyimide;
especially
underneath the bridges?  By the way, the bridges are made of chrome and
electroplated gold.  Therefore, the etchants cannot attack these metals.

Thanks,

    Sergio

--

*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
       ._,
     ,_| |._/\              Sergio Palma Pacheco
     |       |o/^^~-._      Radiation Laboratory
   /-'                | ~   3121 EECS Building
   \__/|_            /'     University of Michigan
         \__        | .      Ann Arbor, MI 48109
           |     __/'
           >   /'               Tel: (313) 936-2975
         /'   /'            Fax: (313) 747-2106
         ~~^\/'              e-mail: [email protected]

*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*