A MEMS Clearinghouse® and information portal
for the MEMS and Nanotechnology community
RegisterSign-In
MEMSnet Home About Us What is MEMS? Beginner's Guide Discussion Groups Advertise Here
News
MEMSnet Home: MEMS-Talk: etch through hole on pyrex glass
etch through hole on pyrex glass
2006-12-12
Hui Ju
2006-12-12
Shay Kaplan
Glas Frit Bonding
2006-12-13
Erik Jung
2006-12-13
Gareth Jenkins
2006-12-13
Shay Kaplan
2006-12-13
Anil Agiral
2006-12-14
Pradeep Dixit
etch through hole on pyrex glass
Pradeep Dixit
2006-12-14
Hi,

You can etch through by wet etching 'conc HF etching. You can check the
journal papers by Dr. Ciprian Illiscue by IBN, Singapore. I think its
published in Surface and Coating.

Thanks,
Pradeep




On 12/13/06, Shay Kaplan  wrote:
>
> Gareth,
> ECD does work but the yields is very low, especially in thin wafers - they
> crack once you make the last hole!
>
> Shay
>
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]
> On Behalf Of Gareth Jenkins
> Sent: Wednesday, December 13, 2006 4:03 PM
> To: General MEMS discussion
> Subject: Re: [mems-talk] etch through hole on pyrex glass
>
> You could try electrochemical discharge machining (also known as spark
> erosion).
> I believe two Japanese researchers, Shoji and Esashi, published work on
> this
> a while back, although I can no longer find the reference.
>
>
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>
reply
Events
Glossary
Materials
Links
MEMS-talk
Terms of Use | Contact Us | Search
MEMS Exchange
MEMS Industry Group
Coventor
Harrick Plasma
Tanner EDA
MEMStaff Inc.
The Branford Group
Tanner EDA by Mentor Graphics
Addison Engineering