Hi Peter,
A new E-less Ni shouldn't fire off (outplate).  Where does the fire off
occur? Everywhere, or only on your heater? Indirect heat should be used.
Regards,
Dave Roberts (Wafer Plating Specialist)
Prodigy Surface Tech.  Santa Clara, CA

-----Original Message-----
From: P.E.M. Kuijpers [mailto:[email protected]]
Sent: Thursday, May 10, 2007 11:24 PM
To: General MEMS discussion
Subject: RE: [mems-talk] Au electroplating

Hello Dave,

Another question about wafer plating:
We did install ENIG (Eletroless Nickel/Immersion Gold, Rohm and Haas
chemicals).
After Nickel plating we observed outplating of our Ni bath? We do have N2
bubbling in our bath for extra agitation.
Is there another simple solution to avoid this outplating?