You can buy wafer dicing saw blades and put them onto milling machines.
Its not elegant but it does work.

Regards,

Steven J. Adamson
President IMAPS

Market Manager, Asymtek


-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of
[email protected]
Sent: Wednesday, February 06, 2008 8:50 AM
To: [email protected]; [email protected]
Subject: RE: [mems-talk] Dicing saw

Following this post, I have the same problem. I have been looking on the
internet for a long time, but basically dicing saws (for silicon, in my
case) are really bulky, big and expensive. It would be nice to have a
dicing saw that can just be put on a table for cutting wafers or dicing
smaller samples.

Any suggestions?