Hi all,

I am just starting to pattern a 50-µm-thick SU-8 layer on Si wafer by
photolithography. However, I found the SU-8 layer is not uniform. The center
of the SU-8 layer is about 8 µm higher than the part near the edge (except
the edge beads). My spin speed is: 500 rpm for 5 s with acceleration of 100
rpm/second, then spin at 3000 rpm for 40 s with acceleration of 1000
rpm/second. If any one has any solution for this problem, please tell me.

Thank you!

Cheers,

Meifang