What substrate material are you using? How thick are the metal layers?
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Yinyan Gong
Sent: Monday, January 19, 2009 7:34 AM
To: [email protected]
Subject: [mems-talk] Deposition of Chromium and Platinum
Dear All,
I have a hard time to deposit Chromium (50nm) followed by Platinum
(100nm) using a e-beam evaporator. After lift-off (using 1165), some
areas of the metal layer will peel off and the rest part has very rough
surface. I note that during deposition of Pt, the temperatures is quite
high and I have to interrupt the deposition when the temperature reaches
90C and let the system cool down before depositing again. Any
suggestions will be appreciated.