A MEMS Clearinghouse® and information portal
for the MEMS and Nanotechnology community
RegisterSign-In
MEMSnet Home About Us What is MEMS? Beginner's Guide Discussion Groups Advertise Here
News
MEMSnet Home: MEMS-Talk: Recipe for NR9
Recipe for NR9
2011-09-08
Xiaohui Lin
2011-09-09
Alex Mellnik
2011-09-12
Jin Yu
Recipe for NR9
Jin Yu
2011-09-12
I think your photoresist too thick, dilute the resist. If you can get
the resist thickness  about 500nm, I don't think there is any problem.

Best regards,

 Jin Yu


-----Original Message-----
From: Xiaohui Lin [mailto:[email protected]]
Sent: 08 September 2011 17:17
To: General MEMS discussion
Subject: [mems-talk] Recipe for NR9

Hi guys I am having a difficult time dealing with NR9-1000P lithography
on glass substrate (1mm thick) coated with Cr/Au (50nm).

It is a clear field mask, so only the pattern region (5um lines) are not
exposed and developed away

spin coat thickness is 1um at 3000rpm


I found that, when exposing using MA6 Ch1 (7.5mJ) for 20s, line will be
almost closed out. But if reduce the time, the bottom may not get enough
expose.

Could anyone suggest the way to optimize the process?

reply
Events
Glossary
Materials
Links
MEMS-talk
Terms of Use | Contact Us | Search
MEMS Exchange
MEMS Industry Group
Coventor
Harrick Plasma
Tanner EDA
Tanner EDA by Mentor Graphics
The Branford Group
Harrick Plasma, Inc.
Addison Engineering