I agree. Ensuring even evaporation of solvent during the bake is essential.
Covering the wafer with a glass dish can help.
You will also see big variations due to edge bead (i.e. thicker on the
outside). A resting step after spinning but before the bake is highly
recommended.

On 27 June 2012 12:54, Bill Moffat  wrote:

> Air turbulence can be the answer.  When engineers were  experimenting with
> super thick resist on photo masks they used to put a second blank mask a
> short distance above the mask being coated.  This protected the resist
> surface from air turbulence.  You may want to use a variation of this.
>  Bill Moffat
>
> -----Original Message-----
> From: [email protected] [mailto:
> [email protected]] On Behalf Of
> Yingtao Tian
> Sent: Wednesday, June 27, 2012 9:36 AM
> To: [email protected]
> Subject: [mems-talk] Ultrathick SU8 photoresist processing
>
> Dear All,
>
> I am trying to make very thick SU8 photoresist on silicon wafer, however,
> I found that, even the resist was spun coated, the surface will not be
> flat. I tried to put over 200 um thick resist but the thickness can vary
> between 180 - 220 across the whole wafer. I have tried to adjust the
> levelness of the hotplate by using an inclinometer and it was almost
> perfectly levelled. Somebody suggested that the air turbulence in the
> cleanroom does matter for such very thick resist. But, I have no evidence
> to doubt it.
>
> Anybody has ideas?
>
> Thanks,
> Yingtao
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk