I suggest the glass be better and thoroughly cleaned. Use ultrasonic bath
for longer time.

On Monday, March 10, 2014, Janis Klavins  wrote:

> Hello everybody,
>
> I am trying to coat an SU8 material on ITO etched glass. I have a problem
> that during development the SU8 lifts off the glass very easily. if the
> glass sheet is immersed in the developer the SU8 lifts off and floats away.
>
> I believe that this is a baking problem (too much or not enough) after
> coating the SU8. I am using a two step kiln 65 degrees ( 1 min)  and 95
> degrees (4 min). The same settings for post exposure bake.
>
> Has anyone seen a problem like this?
>
> --
> Best regards,
> Mr. Janis Klavins
> EuroLCDs
> Phone: +37163600300
> Mobile: +37126141049
>
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk