A MEMS Clearinghouse® and information portal
for the MEMS and Nanotechnology community
RegisterSign-In
MEMSnet Home About Us What is MEMS? Beginner's Guide Discussion Groups Advertise Here
News
MEMSnet Home: MEMS-Talk: RE: Multiple Resonance Frequencies
RE: Multiple Resonance Frequencies
1999-02-14
Karl Cazzini
1999-02-13
Ng Chee Keong David
1999-02-14
Karl Cazzini
1999-02-14
Robert Conant
RE: Multiple Resonance Frequencies
Robert Conant
1999-02-14
Mr. Lee:

If you are using a square wave that is not centered around 0, for example if
it goes from 0 to 10 volts, then it approximates a sine wave
V = Vac sin(w * t) + Vdc
where Vac = Vdc = 5 volts, and w is the frequency.  Since the force on the
combdrive goes as the square of the voltage, the force is proportional to

V^2 = [Vac * sin(w t)]^2 + Vac * Vdc * sin(w * t) + Vdc ^2
    = Vac^2 * sin(2 * w * t) + Vac * Vdc * sin(w t) + Vdc ^2

so there are two dominant frequency terms -- one at the frequency w, and one
at 2 w.  You are driving with a square wave, so things are even messier
since there is energy in a large range of different frequencies.

I would recommend driving with a sine wave instead of a square wave.  If
you're having trouble finding a high-voltage sine wave generator, try using
a transformer to convert a low voltage sine wave into a high voltage sine
wave (it's really easy, and MUCH cheaper than buying equipment to generate a
high voltage sine wave).

Good luck!

***********************************
Robert Conant
BSAC / UC Berkeley
Berkeley CA, 94720-1774
[email protected]
http://www-bsac.eecs.berkeley.edu
***********************************


-----Original Message-----
From: Chua Bee Lee [mailto:[email protected]]
Sent: Thursday, February 11, 1999 5:35 AM
To: [email protected]
Subject: Multiple Resonance Frequencies


Dear All,
        I have been working on folded beams resonators using square waves
to drive them. As I adjusted the driving frequency towards the resonance
value, I observed resonance at smaller amplitudes  at lower frequencies
prior to the one that I was expecting. I would appreciate if someone can
provide some insight on that.

        Thank you.
        CHUA Bee Lee
        Department of Mechanical and Production Engineering
        National University of Singapore


reply
Events
Glossary
Materials
Links
MEMS-talk
Terms of Use | Contact Us | Search
MEMS Exchange
MEMS Industry Group
Coventor
Harrick Plasma
Tanner EDA
Harrick Plasma, Inc.
The Branford Group
Process Variations in Microsystems Manufacturing
MEMS Technology Review