A chemical etching technique might work, but I have no experience.  If you
want to pursue, check with proceedings of the Electrochemical Society or a
plating magazine.  Good luck.



-----Original Message-----
From: Karl Cazzini 
To: [email protected] 
Date: Tuesday, April 27, 1999 5:29 AM
Subject: forming feather edges / burrs in metals


>I am trying to form, good quality, homogeneous feather edges (or burrs) on
>thin metal strips (0.006" thick), by grinding and / or polishing methods. I
>realise that most peolple want to eliminate these "burrs" or feather edges,
>however I actually require them! I am grinding stainless steel strips (~1
>inch long, 0.006" thick) at angle of about 15 degrees, on a rotating
>abrasive disk. If the abrasive is too course, a poor quality, inhomogeneous
>feather edge results. I want to form good quality, homogeneous and
>REPRODUCEABLE feather edges in SS, for a MEMS application that I am working
>on. Any and all assistance would be most welcome. Please remember that this
>is something I must be able to do in-house. I do have access to quality
>polishing and grinding equipment. Any assistance would be greatly
>appreciated. Thanks very much, Karl.
>
>
>******************************
>* Karl H. Cazzini (Ph.D)     *
>* Conifer Group & Associates *
>* 116 Cochituate Road        *
>* Framingham MA 01701        *
>* USA                        *
>*                            *
>* Tel(W): (508) 620 8845     *
>* Fax(W): (508) 620 8830     *
>* Tel(H): (508) 875 2009     *
>******************************
>
>
>
>