>
> REGARDING                Information on translators
>       I am looking for information on the best way to translate between
Cadence
> Layout Editor files (or GDSII, also called stream output) and AutoCad DXF
> format, or NASTRAN or PATRAN for finite element analysis.  We are mainly
> interested in supported commercial software rather than university unsupported
> software.  Any information on commercial vendors of such translation software
> would be greatly appreciated.
>              Jon Bernstein
> [email protected]
>
>
>
>
Jon, I use the two-way GDSII<-->DXF translator from

Artwork Conversion Software
1320 Mission Street, Suite 5
Santa Cruz, CA 95060
Fax: (408)426-2824

It costs around $3000 and runs under DOS with a hardware key to prevent
simultaneous use on multiple machines. It works best if all GDS cells (also
called structures) are smashed flat before translation to DXF, but handles some
cell instances without problems. I have limited experience with the opposite
path from DXF to GDS.

Good luck in your search. Please post results to the [email protected] list.

Phil
--
 ************* __  *************   Phil Barth
***********   / /    ************  Project Engineer
*********    / /        *********  Analytical & Medical Laboratory
*******     / /___ ______ *******  Hewlett-Packard Laboratories
******     / __  // __  /  ******  email: [email protected]
******    / / / // /_/ /   ******  US Mail: 3500 Deer Creek Road
*******  /_/ /_// ____/   *******           Building 26U
********       / /      *********           Palo Alto, CA 94304
**********    / /     ***********  Phone:   (415) 857-5804
 *********** /_/ ***************   Fax:     (415) 852-8502