===== Original Message from [email protected] at 12/19/01 4:20 am
>Our company is involved in diamond NanoTools in the 300 to 10 nm(nanometer)
>range.
>
>----- Original Message -----
>From: Jordan M. Berg 
>To: 
>Sent: Wednesday, December 19, 2001 8:07 PM
>Subject: [mems-talk] Suppliers for Diamond Drill Bits?
>
>
>> Any recommendations for good suppliers of diamond drill bits in the <1mm
>> diameter range?
>>
>> Thanks!
>>
>> Jordan Berg
>>
>> --------------------------------------------------------
>> Jordan M. Berg, Ph.D., P.E.
>> Associate Professor of Mechanical Engineering
>> Texas Tech University
>> Lubbock, TX 79409-1021
>>
>> [email protected]
>> _______________________________________________
>> [email protected] mailing list: to unsubscribe or change your list
>> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>> Hosted by the MEMS Exchange, providers of MEMS processing services.
>> Visit us at http://www.mems-exchange.org/
>_______________________________________________
>[email protected] mailing list: to unsubscribe or change your list
>options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>Hosted by the MEMS Exchange, providers of MEMS processing services.
>Visit us at http://www.mems-exchange.org/
===== Comments by [email protected] ("Jim Intrater -- IE") at
12/19/01 4:40 pm
You want a CVD diamond coated drill. Try Crystallume in Santa Clara.