Thanks Vic,

Can you suggest vendors for the equipment or the service?

Thanks,
roger

-----Original Message-----
From:   Vic Kley [SMTP:[email protected]]
Sent:   Monday, February 25, 2002 1:45 AM
To:     [email protected]
Subject:        Re: [mems-talk] Drilling through holes

Less then 3:1 width to height and 12 mils (.012 inch) its a snap to
microdrill, you could easily go to 5:1.

Vic

----- Original Message -----
From: Roger Brennan 
To: 
Sent: Saturday, February 23, 2002 1:05 PM
Subject: [mems-talk] Drilling through holes


> Hi everybody!
>
> I'm now wet etching to make through holes in 12 mil (305 microns) <100>
Si.
>  The desired hole size is about 10 mils by 30 mils  (254 microns by 762
> microns).
>
> Is laser or physical drilling a possible alternative?
>
> How about deep RIE?
>
> Thanks.
>
>
> Roger Brennan
> Home:
> 1403 Forrestal Avenue
> San Jose, CA 95110
> (408)453-0711 (telephone)
> (408)573-9407 (fax)
> [email protected]
>
> Work:
> Endevco
> 355 N. Pastoria Ave.
> Sunnyvale, CA 94085
> 408-739-3533 ext 204
> [email protected]
> _______________________________________________
> [email protected] mailing list: to unsubscribe or change your list
> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing services.
> Visit us at http://www.mems-exchange.org/
_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.mems-exchange.org/