Blunier is it possible to do a sketch showing the 2 areas that etch at different
rates.  I am having a difficult time working out the geometry of your device.
Bill Moffat

-----Original Message-----
From: Blunier, Stefan [mailto:[email protected]]
Sent: Thursday, January 16, 2003 4:14 AM
To: [email protected]
Subject: [mems-talk] Underetch of SOI


Dear collegues
I'm working on SOI wafers developing free hanging structures. During
underetch with HF (48%) I noticed that the etch velocity of the two
Si-SiO2 interfaces is different. SiO2 thickness is 3 microns. Production
is bonding of thick device layer and lapping polishing to a thickness of
50 microns.
The etch velocity at the interface SiO2-device layer is faster than the
etch velocity at the interface SupportSi-SiO2. To etch all the oxide
under a 50 micron beam I have to overetch to long so my anchors
underetch to much.
Does anybody know this problem and how to avoid it?
Thanks
Stefan


_____________________________________________________
Dr. Stefan Blunier
ETH Zuerich, Zentrum CLA G 21.2
Institute of Mechanical Systemes
Tannenstrasse 3
CH - 8092 Zuerich
Switzerland

Phone:   +41 1 632 77 64
Fax:  +41 1 632 11 45
e-mail: [email protected]
__________________________________________________


_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/