Loren,

Have you actually worked with this glass. I have found it to be almost
impossible to work with, and expensive.  If someone has a lot of
experience with this glass please let me know, I would like to learn the
"tricks".

Thanks,
Charles Ellis
Auburn University

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of St.Clair, Loren
Sent: Tuesday, January 28, 2003 7:47 AM
To: 'General MEMS discussion'; '[email protected]'
Subject: RE: [mems-talk] Photo-definable glass

Sarah,

Foturan from Schott Corporation is a material that can be patterned
using a
standard mask aligner (300-320nm) and HF.  Craig Wurzel can be contacted
at
[email protected] if you have any questions about prices.


Hope this helps,

Loren St. Clair


 -----Original Message-----
From:   Sarah Schwab [mailto:[email protected]]
Sent:   Friday, January 24, 2003 4:38 PM
To:     '[email protected]'
Subject:        [mems-talk] Photo-definable glass

Hello there
I am looking for some information on photo-definable glass.
Could anyone please help me with the following:

Suppliers?
Approx cost per wafer 4" diameter - sample quantities?
Minimum thickness?

Many thanks
Sarah


_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/

_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.memsnet.org/