Dear MEMS group,
I am planning to place some ferrules in a chuck
and seal the intermediate gap (between ferrule and chuck) with a sealant.These
ferrules are then to be polished. So the sealant must be hard enough such that
the ferrules are not displaced while polishing. The sealant must also withstand
a temperature of 200C.Can anyone help me in this regard? Please also let me know
how to remove the sealant completely after use. Thanks in advance.
Rajib

RAJIB CHAKRABORTY
Centre for Photonics Technology
Dept. of Electrical & Computer Engg.
Virginia Polytechnic and State University
Email: [email protected]